Table of Contents
Advertisement
Section 3 - On the Water
The primary concern is the boat changing direction while in the midst of the jump. In such cases the landing may cause the
boat to violently veer in a new direction. Such a sharp change in direction or turn can cause occupants to be thrown out of their
seats or out of the boat.
There is another less common hazardous result from allowing your boat to launch off of a wave or wake. If the bow of your boat
pitches down far enough while airborne, upon water contact it may penetrate under the water surface and submarine for an
instant. This will bring the boat nearly to a stop in an instant and can send the occupants flying forward. The boat may also veer
sharply to one side.
Impact with Underwater Hazards
Reduce speed and proceed with caution whenever you're driving a boat in shallow water or in areas where the waters are
suspected of having underwater obstacles that could be struck by the underwater drive components, rudder, or the boat
bottom.
IMPORTANT: The most important thing you can do to help reduce injury or impact damage from striking a floating or
underwater object is control the boat speed. Under these conditions, boat speed should be kept to a maximum speed of
24–40 km/h (15–25 mph).
Striking a floating/underwater object may result in an infinite number of situations. Some of these situations could result in the
following:
•
The boat could move suddenly in a new direction. Such a sharp change in direction or turn can cause occupants to be
thrown out of their seats or out of the boat.
•
A rapid reduction in speed. This will cause occupants to be thrown forward, even out of the boat.
•
Impact damage to the underwater drive components, rudder, and/or boat.
Keep in mind, one of the most important things you can do to help reduce injury or impact damage in these situations is control
the boat speed. Boat speed should be kept to a minimum planing speed when driving in waters known to have underwater
obstacles.
After striking a submerged object, stop the engine as soon as possible and inspect the drive system for any broken or loose
parts. If damage is present or suspected, the power package should be taken to an authorized Mercury MerCruiser dealer for a
thorough inspection and necessary repair.
The boat should be checked for hull fractures, transom fractures, and water leaks.
Operating with damaged underwater drive components, rudder, or boat bottom could cause additional damage to other parts of
the power package, or could affect control of the boat. If continued operation is necessary, do so at greatly reduced speeds.
Operating a boat or engine with impact damage can result in product damage, serious injury, or death. If the vessel
experiences any form of impact, have an authorized Mercury Marine dealer inspect and repair the vessel or power package.
Conditions Affecting Operation
Weight Distribution (Passengers and Gear) Inside the Boat
Shifting weight to rear (stern):
•
Generally increases speed and engine RPM
•
Causes bow to bounce in choppy water
•
Increases danger of following wave splashing into the boat when coming off plane
•
At extremes, can cause the boat to porpoise
Shifting weight to front (bow):
•
Improves ease of planing
•
Improves rough water ride
•
At extremes, can cause the boat to veer back and forth (bow steer)
Page 38
7576
WARNING
!
90-8M0099729
NOVEMBER 2014
eng
Advertisement
Chapters
Table of Contents
