Table of Contents
Advertisement
Appendix A. Status Buffer Messages
ACCESS_INFO_DISC
The network was unable to deliver access information to the far end.
Bad AT bit field
User issued an AT command with an argument that was out of range.
Bad call type
ISU 512 placed a call with an improper call type.
Bad DTE baud
The DTE bit rate does not match a valid bit rate for the protocol selected.
Bad DTE bps
Bonding negotiation determined that the chosen DTE bit rate is invalid.
BAD_INFO_ELEM
Call control error.
Bad phone number
ISU 512 attempted to call an invalid phone number.
BEAR_CAP_NOT_AVA
The bearer channel requested by the user is not available.
Bearer mode
Incoming call is not of a type the ISU 512 can accept.
Bearer info mode
Incoming call information transfer capability is not known.
BONDING (+/- XXX)
The amount of bytes of corrected delay between the B2 and B1 Bearer channels
(XXX can range from -8000 to +8128 bytes).
BPS mismatch
Bonding negotiation found a bit rate mismatch.
BUSY
The called number is busy.
CallID 1 in use
ISU 512 tried to place a call using SPID 1 though SPID 1 was already in use.
61202.086L1-1
ISU 512 User Manual
71
Advertisement
Table of Contents
