Advertisement
Quick Links
LARGE FULL-MOTION TV WALL MOUNT
V1.0
PSLF4
Thank you for choosing our product! We strive to provide the best quality
and services for our customers. Would you kindly share your experience
on Amazon if you are satisfied? Should you have any issues, please don't
hesitate to contact us.
Telephone：800-5566-806 Mon-Fri 10am - 6pm (PST) (USA) (CAN)
Email：supportus@perlesmith.com (US/CA/DE/UK/FR/IT/ES/JP/AU)
Advertisement
Related Manuals for Perlesmith PSLF4
Summary of Contents for Perlesmith PSLF4
- Page 1 LARGE FULL-MOTION TV WALL MOUNT V1.0 PSLF4 Thank you for choosing our product! We strive to provide the best quality and services for our customers. Would you kindly share your experience on Amazon if you are satisfied? Should you have any issues, please don't hesitate to contact us.
-
Page 2: Important Safety Information
This product may contain moving parts. Use with caution. DO NOT INSTALL INTO DRYWALL ALONE. Please check www.perlesmith.com for more products and company information. CAUTION! CAUTION! This TV mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage. - Page 3 Step 1 Before TV Bracket Installation Measure the distance between the holes located at the back of your TV (these measures may form the shape of a square, or a rectangle) and check that these taken measures are within the VESA(*) range for this wall mount.
- Page 4 Step 2 Mounting the Monitor Brackets to a TV First of all, make sure the diameter of the Bolt(c to h) your TV requires. Once you have determined the correct diameter, please see the diagram as below. You will thread the Bolt into the TV using the correct Washer(i,j), and using the spacer(k,l,m) if necessary.
- Page 5 Drill 4 pilot holes using a 5/32 in. (4 mm) diameter drill bit. Make sure the depth is not less than 3.35 in.(85mm). 3.35 in. (85 mm) Mount the wall plate using 4 sets of 5/16 lag bolts washers with a 1/2 in. socket wrench (not included). Step 4 Install the Wall Plate to the Wall These anchors are for concrete or brick walls ONLY.
- Page 6 Drill 4 pilot holes using a 3/8 in. (10 mm) diameter drill bit. Make sure the depth is not less than 3.74 in.(95mm). 3.74 in. (95 mm) Use the hammer to knock anchors o into the wall. Install wall plate using lag bolts n, washers p and anchors o. Tighten the lag bolts until they are pulled firmly against the wall plate.
- Page 7 Step 6 Tilt and Level Adjustment +2° -15° - 3.5° A djust TV Lev el Wire Management...