Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Perlesmith PSLFK1
Summary of Contents for Perlesmith PSLFK1
- Page 1 LARGE FULL-MOTION TV WALL MOUNT V5.0 PSLFK1 supportus@perlesmith.com...
- Page 2 WARNING! WARNING! SEVERE PERSONAL INJURY AND PROPERTY DAMAGE CAN RESULT FROM IMPROPER INSTALLATION OR ASSEMBLY. READ THE FOLLOWING WARNINGS BEFORE BEGINNING. If you do not understand the instructions or have any concerns or questions, please contact a qualified installer. Do not install or assemble if the product or hardware is damaged or missing. Not all parts and hardware supportus@per- included must be used.
- Page 3 Supplied Hardware Arm and Wall Plate Front Support Arm Extensions TV Bracket (Left and Right） Philips Screws Philips Screws Spacers Washers Spacers M6 x 15mm M8 x 15mm L10mm Ø6mm L5mm M6 x 30mm M8 x 45mm M4-5-6 Socket Lag Bolts Washers Spanner Ø8mm...
- Page 4 Step 1 Before TV Bracket Installation Measure the distance between the holes located at the back of your TV (these measures may form the shape of a square, or a rectangle) and check that these taken measures are within the VESA(*) range for this wall mount.
- Page 5 Step 2 Install TV Bracket For Flat Screen TV For Curved TV...
- Page 6 Step 3A Use a stud finder (not included) to locate wood studs. Mark the edge and center locations. Ensure marking at the center of the stud. Use wall plate 01 to mark mounting location x4 locations.
- Page 7 Drill 4 pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Make sure the depth is not less than 2 3/4” (70mm). in. (70 mm) Mount the wall plate using 4 sets of 5/16 lag bolts (a) and washers with a 1/2 in.
- Page 8 Install Arm Extensions then Fasten It Step 4 Use socket spanner C to remove the pre-assembed nuts and screws from the extensions 02 and save them to use. Insert the extensions into the Fasten the nuts and screws S4 x8. Hang 02 and 03 into 01 , and using Screw Driver secure with pre-assembled screws and washers...
- Page 9 Step 5 Hang TV onto the arm extensions Hang TV with brackets [S3] Remove the preassembled screws [S3] and save to use, then raise the safety locks. Step 6 Secure TV Secure TV with brackets against the arm extensions with the pre-assembled screws [S3] .
- Page 10 Step 7 Tilt Adjustment To adjust the tilt in both sides, loosen both tilt levers and move panel to desired position. Tighten both tilt levers to hold 4PCS desired tilt. ！ LOOSEN TIGHTEN ！ TIGHTEN Step 8 Level Adjustment If needed, the TV can be leveled +/-3 degrees. Loosen 2 screws [S1] Level the TV Tighten 2 screws...
- Page 11 Thank you for choosing our product! We strive to provide the best quality and services for our customers. Would you kindly share your experience on Amazon if you are satisfied? Should you have any issues, please don't hesitate to contact us. Telephone：800-5566-806 Mon-Fri 10am - 6pm (PST) (USA) Email：supportus@perlesmith.com (US/CA/DE/UK/FR/IT/ES/JP/AU)