Memory Functions (Only With The Pulse Panel) - Kemppi MasterTig ACDC 3500W Operating Manual

3.4.13 Fusion spot welding (only with a pulse panel)
0 - 10 s
SPOT
WELD
Select fusion spot welding by pressing the special
operation key SPOT WELD. To show that you have
selected fusion spot welding, the signal light next to the
key goes on. You can select the spot time that you want
with the current knob. The time selected is shown in the
numerical display during the adjustment. Five seconds
after the adjustment, the display returns to the set value
of the current and you can adjust the welding current.
The time shown in the display means the time you have
the welding current. The down-slope and the up-slope
times are increasing the burning time of the arc.
3.5 Memory functions (only with the pulse
panel)
By means of the memory functions you can save 9
panel settings in the permanent memory. All adjustable
or chosen values are saved in the memory. When the
memory function is not in use, the numerical display of
the memory section is black.
With the CHANNEL key you can select the channel to be
read and used for the saving of a setting.
The MEM / PANEL key is used to select whether to use the
values in the memory or values controlled from the panel.
The function of the SAVE key is two-phased. When you
press it once, you select the values to be saved. In this
case the light SAVING is blinking to show that you are
performing a saving operation. When the light is blinking,
you can find the channel into which you want to save the
values. When you press the key again, the information is
saved in the memory.
3.5.1 Calling the values from the memory
19
© Kemppi Oy 2021
1. Press the CHANNEL key so many times that the
numerical channel display shows the number of
the channel that you want. At the same time, the
signal lights of the panel show you the selections
of the selected channel and the current display
shows you the set value of the current. You can
see the other values of the welding parameters
by pressing the parameter key or by turning the
potentiometer. All the values are locked, which
means that you cannot change them while the
MEM signal light is on.
PANEL MEM. SAVING
2. If you want to change the values found, press the MEM
/ PANEL key and the PANEL signal light comes on
and you can change the values.
PANEL MEM. SAVING
3.5.2 Saving a welding situation (parameters) in the
memory
MasterTig ACDC 3500W R01