230 Volt Conversion 30 Or 50 Amp; Model Only); 115 Volt Conversion 30 Amp (Pace Model Only) - HotSpring HOT SPOT RELAY Owner's Manual

230 VOLT CONVERSION 30 OR 50
AMP
(PACE MODEL ONLY)
Conversion instructions
NOTE: An Authorized HOT SPRING Spa Technician must reconfigure
spa using the soft jumpers.
A licensed electrician must install the sub-panel (available from your
HOT SPRING Spa Dealer) to supply
power to the spa. The sub-panel must be placed in sight of the spa, at a
minimum distance of 5 feet (1.5 m) away.
230VAC, 30/50 Amp
2-Pole Circuit CIircuit
Breaker (Non GFCI)
#8 AWG White, Neutral
#10 AWG Green, Ground
#8 AWG Black, L1
30/50A
50A
#8 AWG Red, L2
Main Service
Electrical Panel
Less Than 100 FT (30 m).
115 VOLT CONVERSION 30 AMP
(PACE MODEL ONLY)
Conversion instructions
NOTE: An Authorized HOT SPRING Spa Technician must reconfigure
spa using the soft jumpers.
A licensed electrician must install the sub-panel (available from your
HOT SPRING Spa Dealer) to supply
power to the spa. The sub-panel must be placed in sight of the spa, at
a minimum distance of 5 feet (1.5 m) away.
Electrical Requirements
WIRING ILLUSTRATION
OPTIONAL 30/50A, 230V SUBPANEL CONVERSION CONNECTION
230 VAC, 24/40A, 60HZ, CONVERTED MODELS
30/50A
50A
Sub-Panel with
GFCI Breaker
Page 25
Power Jumper Position
2 Position Power Jumper
must be removed on the
Terminal Block to operate
See Wiring
230 VAC Spa Models
Illustration
below
N, Neutral, #8 AWG White
L2, Hot, #8 AWG Red
L1, Hot, #8 AWG Black
Ground, #10 AWG Green
More than 5 feet (1.5 m)
the Sub-Panel must be within
sight of the spa
Do Not Exceed 50 Feet (15 m)
Power Jumper Position
2 Position Power Jumper
must remain on the Terminal
See Wiring Block to operate 115 VAC
Illustration on
next page
230 VAC Wiring
(50A Converted)
Control Box
115 VAC Wiring
(30A Converted)
Terminal Block
Power Jumper
Spa Models