Table Of Contents; Please Read This First - Carlin 201CRD Instruction Manual

Model 201CRD & 301CRD Advanced Oil Burners - Instruction Manual

PLEASE read this first . . .

Contents
PLEASE read this first .............................................................2
General information ................................................................3
Codes and standards ..............................................................3
1. 201 & 301 Oil nozzles ........................................................3
2. Prepare site • assemble burner • mount burner ......4
3. Prepare burner .................................................................10
4. Adjustment and verification .............................................16
5. Annual start-up and service ............................................17
6. Repair parts .....................................................................18
7. Maintenance/service procedures ....................................20
Warranty ...............................................................................21
User care and maintenance ....................................Back cover
Special attention flags . . .
Please pay particular attention to the following when you see them through-
out this manual.
Notifies you of hazards that WILL cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that CAN cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor personal
injury or property damage.
Notifies you of special instructions on installation, operation or
maintenance that are important, but are not normally related
to injury or property damage hazards.
- 2 -
Before installing or servicing . . .
Should overheating occur:
(1) Shut off the oil supply to the burner.
(2) Do not shut off the control switch to the circulator
or blower.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property dam-
age.
Installer/service technician . . .
• Read all instructions before proceeding. Perform all procedures, and
in the order given to avoid potential of severe personal injury, death or
substantial property damage.
• Before leaving the site after startup or service, review the User care and
maintenance page with the user. Make the user aware of all potential
hazards and perform the training outlined below.
Installer/service technician - Train the user . . .
• To properly operate the burner/appliance per this manual and the
appliance instructions. See User care and maintenance.
• To keep this manual at or near the burner/appliance for ready access
by the user and service technician.
• To contact the service technician or oil dealer if he encounters problems
with the burner/appliance.
• To keep the appliance space free of flammable liquids or vapors and
other combustible materials.
• To never use laundry products, paints, varnishes or other chemicals in
the room occupied by the burner/appliance.
• To contact the service technician at least annually for startup and
burner/appliance service.
When servicing the burner . . .
• Disconnect electrical supply to burner before attempting to service to
avoid electrical shock or possible injury from moving parts.
• Burner and appliance components can be extremely hot. Allow all
parts to cool before attempting to handle or service to avoid potential
of severe burns.
FROZEN PIPES/WATER DAMAGE: This is not a freeze protec-
tion device. Suitable freeze protection monitoring or other
precautions are recommended to protect against ruptured
pipes/water damage caused by fuel outage, safety related
fault conditions, or equipment failures.
MN2301 030521