Steelcase Elective Elements Freestanding Corner Worksurface Manual page 10

TECHNOLOGY MODESTY PANEL
1.
Route wires as needed.
2.
Install goose-neck catch in the
location shown.
3.
Install a modesty panel bracket on
the bottom of the pedestal, and on the
end panel.
4.
Place shoulder screws into brackets
on unit and pivot modesty panel up.
5.
Modesty panel will seat into the
catch when it's in the upright position.
3
5
MODESTY PANEL
4
Center catch side to side
in kneespace.
2
GOOSE
NECK
CATCH
Locate (2) pilot holes on pedestal
and on the end panel, then install
brackets with Euro screws provided.
Note: use the deeper bracket
for the pedestal.
8-1/8"
(206 mm)
Locate from rear
of worksurface and
and drill (2) pilot holes
SIDE VIEW
Page 10 of 10
939500244 Rev D