CommScope NETpodium 1-1671578-1 Instruction Sheet

NETpodium Side Panels (1-1671578-1/1- 1671578-2)
INSTRUCTION SHEET 411 -117006 Jan 2017 REV B
1. Kit content
Bac k side panel
Front side panel
Assembly hardware
2. Mounting a Tool-less Fastener (TF)
2.1. The profile
Groove
2.2. How to install a TF
Insert the TF into the T-channel.
Quarter turn clockwise.
TF is ASSEMBLED in the T-channel, you can still slide it to
choose it's position.
TF is FIXED, you can NOT slide it.
3.
1 pc
1 pc
T -Channel
Insert a TF in the outer T-channel (see paragraph 2.2) of each
NETpodium back pro le at the height of 1078mm measured from
the top surface of the NETpodium bottom pro le.
Pay attention to the following:
The side panel must be positioned in front of the installed bracket.
The lock must be positioned as shown on the picture.
Install the Back Side Panel
P ositioning brackets,
located at the SIDE of
the side panel .
P ositioning bracket,
located at the BOTTOM
of the side panel .
1078mm