Contents Of Stk-Rps-150Ch2 Carton; Contents Of Stk-Rps-150Ch8 Carton; Contents Of Stk-Rps-150Ps Carton - Enterasys A4H124-24 Hardware Installation Manual

Table 2-1 Contents of STK-RPS-150CH2 Carton
Item
STK-RPS-150CH2
Quick Reference
Table 2-2 Contents of STK-RPS-150CH8 Carton
Item
STK-RPS-150CH8
Quick Reference
Table 2-3 Contents of STK-RPS-150PS Carton
Item
STK-RPS-150PS 150 watt DC power supply
USA, NEMA power cord
RPS cable (1 meter in length)
Notice card
Installing an STK-RPS-150PS Into a Shelf
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
If you are using the STK-RPS-150PS as a standalone unit, go to
Power Cord" on page 2-15.
When you receive your STK-RPS-150CH8 shelf, a coverplate will be in place over each
power-supply slot.
To install the power supplies, refer to
1. Place the chassis on a sturdy flat surface where you plan to install power supplies.
2. Align the power supply with one of the slots, then slide the power supply forward until its
front panel is flush against the chassis front panel.
3. Fasten the power supply to the chassis using the captive screws on the PSM front panel.
4. Repeat steps 2 and 3 for each additional power supply.
5. Proceed to "Installing the Shelf into the
instructions.
Installing and Connecting a Redundant Power System
Figure 2-5 or Figure 2-6
Rack" on page 2-13 for the rack mount installation
Enterasys A4 Fast Ethernet Switch Hardware Installation Guide 2-11
Quantity
Quantity
Quantity
"Connecting the RPS Cable and AC
and proceed as follows:
1
1
1
1
1
1
1
1