DAF LF45 Maintenance Manual page 100

EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
Removal and installation
4.12 REMOVAL AND INSTALLATION, AUTOMATIC GEARBOX OIL FILTERS
}
Allison 1000 & 2000 series automatic gearbox
To prevent skin injury, avoid
unnecessary contact with the
drained oil.
Removing the oil filters
1. Clean the oil filter (1) and filter (5), if present,
as well as the surrounding area.
2. Loosen the oil filters on the gearbox and heat
exchanger. Collect any oil that is flowing out.
3. Remove the magnetic rings (2) and (4) and
check them for wear particles.
Note:
5
If there are larger wear particles in the wear
swarf, this points to advanced wear in the
gearbox. The cause must be tracked down.
4. Clean the magnetic rings and the contact
surfaces on the gearbox housing and the
heat exchanger.
Installing the oil filters
1. Fit the magnetic rings (2) and (4) on the
gearbox housing and the heat exchanger.
2. Lightly lubricate the new oil filter (1) and filter
(5), if present, with clean gearbox oil and
place the oil filters on the gearbox and heat
exchanger.
3. Tighten the oil filters until they touch the
contact surface. Manually tighten the oil
filters another 360.
4. Check the oil level, see chapter "Inspection
and adjustment".
4-16
https://www.truck-manuals.net/
2
1
3
ΛΦ45/55 series
V3 00 480
4
6
5
V3 00 556
©
200515