Advertisement
FIG 23
FIG 25
FIG 27
Install Door Surrounds to Jeep
Locate the assembled Passenger side rear door
surround (Fig23). On the bottom of the vertical
pillar portion of the assembled door surround is a
pin that will be inserted into the body tub (FIG 24).
NOTE: as shown in Fig 25, if you have the rubber
seal installed on the body tub, you must remove it
before putting the door surround on!
Insert this pin into the body tub as shown in FIG
26. After inserting the pin, locate the upper portion
of the door surround "C" attachment and push
onto roll bar (FIGs 27& 28).
FIG 30
Secure Front Door Surrounds to Roll Bar
Locate the two sets of screw knobs in each Door
surround box. There should be (2) sets of two
knobs. Line up the door surround "C" attachment
holes with the vertical holes in the roll bar. Slip the
front knob through the hole in the front door sur-
round (FIG30).
FIG 32
FIG 24
FIG 26
FIG 28
FIG 29
Make sure the front seal is snug against the
windshield seal as shown in FIG 29. The "C"
should fit in the cutout of the roll bar pad.
Line up the threads in the "C" with the top hole in
the roll bar.
Repeat this procedure on the Driver's side.
FIG 31
Tighten the knob securing the front door surround.
Repeat this procedure on the back of the door
surround and on the other side of the vehicle.
Finally, tighten all four knobs. All knobs on both
sides of the vehicle should be secured to the roll
bar. This completes the installation of the door
surrounds to your vehicle.
Step 4: Install Center Bow to the Vehicle Locate
the center bow assembly (Fig 32). With a friend,
place the bow assembly over the roll bar and line
up the assembly to the original upper bow mount
bracket (Fig 34) that were left on the vehicle. The
center bow should be towards the rear of the
vehicle as shown in Fig 33.
Line up the Quick release knuckle with the upper
bow mount bracket attachment and attach each
side of the center bow assembly to the bracket
(Figs 35, 36, 37 & 38).
Repeat on other side of vehicle.
5
Advertisement
