Vacuum Pump (Tfk 12); V-Belt - probst SH-1000-MINI Operating Instructions Manual

Operating Instructions
Check oil fill level (level indicator)
Are the vacuum hoses in good condition (not brittle, not
kinked, no worn sections and no leaks)?
Are all connections (hose clamps, etc.) tight?
Are type, load capacity and warning signs in a complete and
legible condition?
Are the operating and maintenance instructions available and
are operators familiar with them?
Check all load-bearing parts (e.g. suspension) for deformation,
wear or other damage.
Clean suction plate / Inspect for cracks,
evenness of sealing lip, etc. Replace if necessary
Has the test label been updated?
General condition of the device
Leak test
Draining the condensation water
Condition of load securing chain 1)
1) Once the load has been held by the load securing chain, the load securing chain must be properly tested and replaced if
necessary. Damaged load-securing chains must not be used any further!!
7.3

Vacuum pump (TFK 12)

See vacuum pump operating instructions (in appendix)
7.4

V-Belt

•
Check the V-belt tension monthly.
•
The V-belt must not protrude more than 1cm or it will need to be rest retched.
•
Procedure:
•
Replace the protective cover
31 / 34
Maintenance and care
V4
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
GB