probst SH-1000-MINI Operating Instructions Manual page 7

Operating Instructions
•
Generally, the load (stones slab) is only to be sucked in the
middle, otherwise the load hangs diagonally under the
device which may cause a breaking of the load - especially
when lifting large stone slabs with a small suction plate.
•
Standard suction plates are not suitable for the transport of
glass plates!
Only suction plates of the manufacturer PROBST shall be used, which shows doubtless a maximum load
capacity at a pressure of - 0.6 bar at the carrying capacity sticker. In unclear circumstances the vacuum device
and the suction plate may not be put into operation. The manufacturer must be contacted!
•
Some suction plates which can be mounted to the device will reduce its carrying capacity.
The maximum load is indicated on each suction plate.
•
Use only suction plates which are approved for this device!
•
Do not exceed the maximum carrying capacity of the suction plates!!!
Danger: Load (stone slabs) will fall down!
NOT ALLOWED ACTIVITIES:
Unauthorized alterations of the device and the use of any self-made additional equipment could cause
danger and are therefore forbidden!
Never exceed the carrying capacity/working load limit (WLL) and the nominal width/nominal size of the
device.
All unauthorized transportations with the device are not allowed:
•
Transportation of people and animals.
•
Transportation of other loads and materials than described in this manual.
•
Never suspend any goods with ropes, chains or similar at the device.
6 / 34
General
V4 GB