Cleaning Nozzle And Injector Ring - Coca-Cola freestyle 8000 User Manual

Hide thumbs Also See for freestyle 8000:

Table of Contents

maintenance

cleaning nozzle and injector ring

How to properly clean the nozzle

Locate the nozzle. Using a clean cloth to protect your

fingers, twist nozzle counter-clockwise, and then pull down

to remove.

Scrub the nozzle at a 45° angle with dish soap using the

blunt end of the nozzle brush (small parts #149326).

Rinse the nozzle in warm, clean, drinkable water.

Place nozzle in approved sanitizer solution (Kay-5). Shake

nozzle when submerging to remove any air bubbles and

soak the nozzle for a minimum of 2 minutes.

CAUTION: DO NOT SOAK NOZZLES OVERNIGHT!

Dip the pointed end of the nozzle brush (small parts

#149326) in sanitizer solution and scrub the injector ring at

a 45° angle. Focus on the small holes where ingredient

comes out and the interior area where the nozzle was

connected to the ring (inner ring). To access the interior

surfaces of the inner ring, use the wire handle nozzle brush

(small parts #16586). Wipe injector ring with a clean cloth

and sanitizer and allow to sit for 2 minutes. Then repeat with

fresh sanitizer solution.

Allow the nozzle to "AIR DRY", then use a clean cloth to

reinstall nozzle and lock into place turning clockwise.

NOTE:

Take extra care to ensure the nozzle is inserted

completely and locked into place. Test by pouring a

sparkling beverage.

Table of Contents

Show Quick Links

Table of Contents