Failure Codes And What To Do In Case Of Failure - Kernau KDI 4853 Instruction Manual

FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

ERROR CODE
F5 Inadequate water supply
Error of continuous water
F3
The waste water in the ma-
F2
chine cannot be discharged.
F8
Alarm is active against
F1
FE Faulty electronic card
Overheating error (tempe-
F7 rature in the machine is too
F9 Divisor position error
F6
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine filters are not clogged.
If detergent residues are left in the detergent compartment
• Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
ERROR
DESCRIPTION
• Make sure the water input tap is totally open and that there is no
water cut.
• Close the water input tap, separate the water input hose from the tap
and clean the filter at the connection end of the hose.
• Restart your machine, contact the service if the error resumes.
• Close the tap.
input • Contact the service.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the program cancellation
command.
• If the error continues, contact the service.
Heater error Contact the service.
• Power off your machine and close the tap.
water overflow • Contact the service.
Contact the service.
Contact the service.
high)
Contact the service.
Faulty heater sensor Contact the service.
CONTROL
EN
58