Spray Arms; Hose Filter - Kernau KDI 4853 Instruction Manual

Water is prevented by the inlet hose filter so as to avoid any damage to your machine
because of any contamination (sand, clay, rust etc.) that might be occasionally carried
in through the mains water supply or the indoor plumbing, and to forestall such com-
plaints as yellowing and formation of deposits after washing. Check the filter and the
hose from time to time and clean them if necessary. To clean the filter, first turn off
your tap and then remove the hose. After removing the filter from the hose, clean it
under the tap. Insert the cleaned filter back into its place inside the hose. Refit the hose.

Spray arms

Check whether or not the holes for the upper and lower
spray arms are clogged. If there is any clogging, remove the
spray arms and clean them under water.
You can remove the lower spray arm by pulling it upwards,
while the upper spray arm nut can be removed by turning
it to the left.
Be sure that the nut is perfectly tightened when refitting the
upper spray arm

Hose filter

EN
57