Table of Contents
Advertisement
3 Electrical installation
Ready for operation signal BTB
Relay
signal contact
contact values
The ready for operation signal (BTB) shows the CNC/PLC
that the drive is ready for operation.
Switch BTB- signals of several axes in one row.
delay after switching on mains
Function
Ready for operation
Not ready for operation
Error
BTB turns off with
Overtemperature
Overvoltage
Short, Line-to-earth-fault
Voltage error
To reset store switch off/on enable
Caution:
Use BTB-contact always with CNC/PLC - control
or with emergency-stop circuit !
Self-starting possible!
Fault memory is not effective with all faults !
"Blocked" Indication
Current demand
Normal
Overload
Analogue measuring putputs
Function
Connection
Value peek current
Value steady current
BAMO A1, A2 60-500
X2:12 - X2:13
max. 48V; 0,5A
>>>
max. 1sec.
Indication
LED bright green
LED glims green
LED bright red
Outpu X2:14
> +10V
< +2V
Motor current display
X2:9 , X1:7
+5.0V
+2.5V
BTB-Relay
Contact closed
Contact open
Contact open
Error is
not stored
stored
stored
not stored
Speed display
X2:8 , X1:7
15
Advertisement
Table of Contents
