Step 8 - Verify Basic M8199A Operation; Step 9 - Install Keysight Io Libraries Suite (Not Required For M8100A-Bu6) - Keysight M8100A Series Getting Started Manual

Step 8 - Verify Basic M8199A Operation

Step 9 - Install Keysight IO Libraries Suite (not required for M8100A-BU6)

Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide
After powering ON the connected hardware components, you can verify if
you have correctly set up the hardware if:
• a steady green status light is displayed on the ESM of the M9505A AXIe
Chassis indicating that the chassis has powered up successfully.
• the Access LED on the front panel of the instrument module turns on
indicating that the module is in a power- ready state.
• the Out of Service (OOS) LED on the front panel of the M9537A AXIe
Embedded Controller turns off. (Applicable only when you are using
M9537A AXIe Embedded Controller as the host computer).
If the chassis does not power up to a steady green Status light, or powers
up to a steady red light, the chassis has detected a failure and requires
service.
If the Fail LED on the front panel of the instrument module is steady red
and does not turn off, it indicates a power fault condition. In such a
situation, the instrument module may require repair/service.
Contact your Keysight representative to replace or service the
chassis/module. See
page 43.
IO Libraries Suite version 17.1 or later is required. Always use the latest
version of the Keysight IO Libraries.
Perform this step if you are setting up an M8100A-BU5 system or the
NOTE
host computer you are using as part of the M8100A system requires I/O
library installation.
1 Disconnect any devices connected to the host computer.
2 If open, close all applications on the host computer.
3 Insert the Automation-Ready CD in your CD-ROM drive or download
and install the IO Libraries from www.keysight.com/find/iosuite.
4 Follow the instructions as prompted during the installation.
5 After installation, you will see the Keysight IO icon in the taskbar
notification area of the host computer screen.
Contacting Keysight Service and Support
Basic Setup for M8100A
on
2
35