Keysight M9537A Axie Embedded Controller Module; Host Computer - Keysight M8100A Series Getting Started Manual

Keysight M9537A AXIe Embedded Controller Module

Host Computer

Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide
The M9537A AXIe Embedded Controller is a one slot module that you can
install in the M9505A AXIe chassis like any other instrument module. This
module acts as a host computer when installed in the M9505A AXIe
chassis. It is always installed in slot 1 of the M9505A AXIe chassis.
The following figure displays this module.
Figure 4 M9537A AXIe Embedded Controller Module
A host computer is used to:
• host all the software components of the instrument modules needed to
control, configure, and use the modules.
• communicate with the ESM of the M9505A AXIe chassis to allow you to
monitor and control the chassis.
A host computer can be:
• the M9537A AXIe Embedded Controller module.
• a laptop with a USB port.
• a desktop PC with a USB port or x8 or wider PCIe slot for the cabled
PCIe adapter card.
Refer to the Computer Hardware and Software Requirements
for external host computer minimum requirements.
Introduction 1
on page 28
19