Erase All Settings, Software Reset; Carry Out Hardware Reset - RADEMACHER RolloTron Comfort 1623 45 19 Translation Of The Original Operating And Assembly Manual

15.7.8 Erase all settings, software reset

If necessary, you can erase
all of your settings and
return the RolloTron Com-
fort system to its original
factory settings.
1.
Simultaneously press and
hold all four buttons for 5
seconds, until all of the icons
are shown on the display.

16. Carry out hardware reset

A hardware reset can be carried out in the event that the
RolloTron Comfort fails to react to commands.
ATTENTION!
Never press the reset button when the motor is running,
as otherwise the end points will be modified.
i
A hardware reset causes the internal power supply to
the RolloTron Comfort to be briefly interrupted. All of the
previously configured settings will be saved apart from
the time and date.
+
-
2.
Next, the device's software
version will be displayed for
a few seconds.
All settings will be erased
and reset to the default fac-
tory settings. Carry out the
settings again as specified
from page 28 onwards
(installation wizard).
1.
Press the Reset button using a sharp
object (e.g. a paper clip).
EN
61