Creo Color Controller C-80 Technical Manual page 51

7. Check that the density difference between the 60% patterns (B) and 50%
patterns (C) is clearly visible.
8. If a problem appears on the test print, perform the following steps:
•
For solid color problems: On the printer control panel, enter the SP mode,
and then execute the process control with SP3-820-002.
•
For density difference problems: Perform color calibration on the Color
Controller C-80.
Note: If the job does not print or is waiting in the Print Queue, make sure that the default
virtual printer parameters are set to the current finishing device. (
Finishing
).
35
Job Parameters >