Replacing The Power Supply; Removing The Power Supply - Creo Color Controller C-80 Technical Manual

5.9

Replacing the Power Supply

5.9.1 Removing the Power Supply

6. Connect the SATA2 cables into the back of each drive. Make sure that the
other end of each cable is connected to the appropriate connector on the
system board.
Figure 42: SATA2 connectors on the system board
7. Route each cable so that it does not block the air flow to the rear of the drives.
8. Connect a power cable to the back of each drive. The connectors are keyed
and can be inserted only one way.
Note: Do not route the cables over the microprocessor and memory.
9. Connect the hard disk fan to the system board (Fan 3).
10. If you have other options to remove or replace, do so now.
11. Return the side cover. See Placing the Side Cover on page 95.
12. Reconnect all external cables and power cords, and turn on the server.
Perform the following procedures to replace the power supply.
Tip: It is easier to perform the following procedures if the server is on its side.
1. Review Safety Information (Multi-Language) on page v .
2. Turn off the Color Controller C-80 and peripheral devices.
3. Disconnect all AC power cords and external cables.
4. Remove the side cover. See Removing the Side Cover on page 94.
5. Disconnect the power supply cables to the drives, and to the system board
(JPW1, JPW2).
6. Remove the four screws that secure the power supply to the server from the
rear of the server, using one hand to hold the power supply inside the server.
See Figure 43 on page 122.
Fan 3
DVD R/W
System disk
Image disks
121