Creo Color Controller C-80 Technical Manual page 25

8. Shut down the Color Controller C-80.
9. Locate the printer interface cable (crossover Ethernet cable) that was shipped
with the Color Controller C-80 and connect one end of the cable to the printer
interface port on the Color Controller C-80, and then connect the other end of the
cable to the correct Ethernet port on the printer.
Figure 3: Printer and Color Controller C-80 connection
Note: To prevent the risk of crosstalk, make sure the printer interface cable does not
touch the system's power cables. The Color Controller C-80 could shut down or image
quality problems could result.
10. Open the
Color Controller C-80 front panel and press the power control button.
Wait approximately two minutes for the
and for the workspace to appear.
11. Turn on the printer using the main power switch.
to reach the idle state
Color Controller C-80
9