Power Management System; Installation And Lubrication; Parts And Maintenance - Ingersoll-Rand 2130XP-TL Product Information

Product Safety Information
Intended Use:
This Air Impact Wrench is designed to remove threaded fasteners and to partially tighten and seat a threaded fastener in preparation
for manually tightening to the recommended torque using a calibrated torque wrench.
Do not use this tool for fi nal tightening of threaded fasteners. The reduced torque in the forward direction is only intended to seat the
fastener in preparation for fi nal torquing. Always manually torque the fasteners to the recommended torque after using this tool.
For additional information refer to Torque Limited Air Wrench Product Safety Information Manual Form 45528239.
Manuals can be downloaded from www.ingersollrandproducts.com.

Power Management System

The power management system on this model can not be adjusted by the user. It is locked at the factory to always provide full power in reverse
and reduced power in forward.
Product Specifi cations
Drive
Model Style
Type Size
2130XP-TL Pistol Square 1/2" 1150 35-55 (47-75) 600 (813)
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air fi lter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off , to prevent hose whipping if a hose fails or coupling disconnects. See drawing 47132782 and table on page 2.
Maintenance frequency is shown in circular arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1. Air fi lter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that
they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
46812228_ed3
Recommended
Torque Range
Impacts
per min.
Forward Reverse
ft-lb (Nm) ft-lb (Nm)
WARNING
Impacting Sound Level dB (A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p w
99.4 110.4
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fi tting
Free Speed Sound Level dB (A)
(ISO15744)
) † Pressure (L ) ‡ Power (L
p
84.0 95.0
EN
Vibration
(ISO28927)
m/s2
) Level *K
w
10.0 1.5
EN-1