Maintenance - baltur TBG 800 MC Instruction Manual For Installation, Use And Maintenance

ENGLISH

MAINTENANCE

Analyse combustion gases and check that the emission values
are correct at least once a year, in compliance with current law.
• Clean air dampers, the air pressure switch with pressure port
and the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Have the burner and the chimney cleaned by specialised
personnel (stove repairer); a clean burner is more efficient, lasts
longer and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposits
deriving from the installation environment and/or from poor
combustion.
• In order to clean the combustion head, its outlet components
must be disassembled. Be careful during the reassembly
operations to exactly centre the gas diffuser with respect to the
electrodes, making sure that they are not earthed, which would
result in the locking of the burner. Verify also that the ignition
electrode spark takes place exclusively between itself and the
drilled disk (see combustion head and electrode disk distance
regulation diagram) for the version without pilot.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the
components following the procedure indicated below:
• unscrew the anchoring screws (11), and open the ventilating
body;
• pull out the ignition and ionisation cables (14) from their
electrode terminals (13);
• unscrew the screw (16) from the buffer (17).
• pull out the entire mixer unit in the direction shown by the arrow.
• Having completed the maintenance work, replace the
combustion head, following in reverse order the operations
described above, after having checked the correct position of
ignition and ionisation electrodes.
11
26
24 / 34
0006160209_201702
11
13
14
14
15
16
17