Table of Contents
Advertisement
4.9 Programming time segments
The thermostat function can be
combined with a timer programme that
allows for up to three time segments to
be programmed. These are indicated
by switch-on times ON 1, 2, 3 and
switch-off times OFF 1, 2, 3. The set
programme will run daily.
1. Check if the hand transmitter is
set at the right time (if you are not
happy with the time, see: 4.3 Day
and night settings)
2. Press the P button (hold down
briefly).
3. Let go of Button P when the time
starts to flash in the top left-hand
corner of the display.
4. Press the right button
"TCOM" (temperature comfort).
TCOM indicates the maximum
temperature during all set time
segments.
5. Set the desired temperature with the
+ or - buttons at increments of 0.5°C.
6. Confirm by pressing the
button).
7. "TECO" (temperature ECO) will now
appear in the display. TECO is the
minimum temperature between
the time segments. This minimum
temperature will be maintained all
day with the exception of the set
time segments.
8. Set the desired temperature with the
+ or - buttons at increments of 0.5°C.
9. Confirm by pressing the
button).
10. Press the right button
flashing time in hours and minutes
appears in the top left-hand corner,
18
11. Use the + and - buttons to set the
12. Confirm by pressing the centre
13. "OFF 1" will then appear (this is the first
14. Use the + and - buttons to set the
15. Confirm by pressing the
16. Programme the other times in the
to display
17. Press P to exit the programme.
18. The
(centre
(centre
, so that a
while "ON 1" appears in the middle
of the display (this is the first "on"
time).
first "on" time at increments of
15 minutes.
button
if you are happy with
the time.
"Out" time).
first "out" time, at increments of
15 minutes.
three segments in this way; should
you not require all time segments,
these other segments should be set
at identical switch-on times.
and
icons on the remote
control indicate that the time
segments have been programmed.
button.
Advertisement
Table of Contents
