1-6. Replacing Function Switches
1-6-5. FILTER LOCAL/ND/CC Switches
c
When opening the side panel during or immediately after use of the unit, be careful as the board panel is
very hot and touching it may result in burns. When opening the side panel to perform inspections and
adjustments, turn off the power and wait 10 minutes for the unit to cool down first.
1. Remove the right side panel. (Refer to Section 1-4 in the installation and maintenance manual.)
2. Remove the two screws, and remove the SW-1011 board.
3. Disconnect the harness connector from the CN1 connector on the SW-1011 board.
4. Desolder a switch that needs to be replaced.
SW-1011 board
CN1
PS2.6 x 8
5. Install a new switch in the reverse order of removal.
1-34 (E)
BVP-9500WS/9500WSP MM