Table of Contents
Advertisement
1-6-6. RET 1 Switch
1. Remove the connector bracket. (Refer to steps 1 to 8 of Section 1-5-5.)
2. Remove the two screws, and remove the SW-1010 board.
3. Desolder the RET 1 switch.
4. Install a new RET 1 switch in the reverse order of removal.
1-6-7. MIC POWER Switch
c
When opening the side panel during or immediately after use of the unit, be careful as the board panel is
very hot and touching it may result in burns. When opening the side panel to perform inspections and
adjustments, turn off the power and wait 10 minutes for the unit to cool down first.
n
Refer to Section 1-8 for details on disconnecting/connecting the flexible card wire.
1. Remove the CN-1927 board. (Refer to steps 1 to 4 Section 1-5-7.)
2. Desolder the MIC POWER switch.
MIC POWER switch
3. Install a new MIC POWER switch in the reverse order of removal.
BVP-9500WS/9500WSP MM
SW-1010 board
Precision
P2.6 x 5
Precision
P2.6 x 5
RET 1 switch
CN-1927 board
1-6. Replacing Function Switches
1-35 (E)
Advertisement
Table of Contents
