Table of Contents
Advertisement
3-2. Video Adjustment
5. Perform the following adjustments observing an RPN-corrected pixel. If two or more pixels which needs
to be corrected are present, perform the adjustments for one of them in the corresponding channel.
1RV1/TG-194 board
Adj. point:
Specification:
Minimize the level difference between the corrected pixel and surrounding pixels.
1RV2/TG-194 board
Adj. point:
Specification:
Minimize phase error on the corrected pixel.
n
If no RPN-corrected pixel is monitored in all channels, set 1RV1 and 1RV2 to their mechanical center.
(Monitor screen)
6. Ensure that all the pixels are corrected properly in the other channels.
Setting after adjustment
TEST OUT switch (side panel) → ENC
3-10 (E)
Corrected
RPN
pixel
NG
Scanning line
NG
OK
TG-194 BOARD (B SIDE)
RV2
RV1
S2
BVP-9500WS/9500WSP MM
Advertisement
Table of Contents
