Table of Contents
Advertisement
3-1. Preparation
Presetting Compensation Data
Before beginning adjustment of VA-180 board, VA-200 board and NR-65 board, preset all compensation data output from
the microcomputer. To preset proceed as follows. By presetting the data, the microcomputer will output the center value of
each data. If you adjust each item without presetting, it cannot be regarded as completion of adjustment.
Presetting
Perform the preset operation on the camera using the viewfinder displays.
n
Make sure the no display appears on the viewfinder before beginning presetting.
Use the DISPLAY switch, MIC 1 LEVEL control and ENTER/CANCEL switch inside the switch box of the camera.
1. Set the DISPLAY switch to OFF. While holding the ENTER/CANCEL switch up in the ENTER position, slide the
DISPLAY switch downward to MENU.
The Maintenance menu appears in the viewfinder.
2. Set the arrow (→) to the "Reference Store" line by turning the MIC 1 LEVEL control, and slide the ENTER/CANCEL
switch upwards to ENTER once.
The Reference Store menu now appears.
3. Turn the MIC 1 LEVEL control and set the arrow to the "All Preset" line and slide the ENTER/CANCEL switch
upwards to ENTER once.
When presetting is completed, a message "Completed" is displayed.
4. Set the DISPLAY switch to OFF.
3-4 (E)
BVP-9500WS/9500WSP MM
Advertisement
Table of Contents
