Craft Interface Sib Leds; Craft Interface Host Subsystem Leds; Ccg Leds; Table 9: Sib Leds On The Ptx5000 Craft Interface - Juniper PTX Series Hardware Manual

PTX5000 Packet Transport Switch Hardware Guide
30

Craft Interface SIB LEDs

The left side of the craft interface has two LEDs for each SIB, which indicate the status
of that SIB. The corresponding SIB slots are labeled
describes the functions of the SIB LEDs.

Table 9: SIB LEDs on the PTX5000 Craft Interface

Label Color
Green
OK
Red
–
Green
ACT
–

Craft Interface Host Subsystem LEDs

Each host subsystem has three LEDs, located to the right of the SIB LEDs on the craft
interface, that indicate the status of the host subsystem. The LEDs labeled
the status of the Routing Engine in slot
show the status of the Routing Engine in slot
HOST1
on page 30 describes the functions of the host subsystem LEDs.

Table 10: PTX5000 Host Subsystem LEDs

Label Color
Green
MASTER
–
Green
OK
–
FAIL Red
–

CCG LEDs

Each CCG has three LEDs—labeled
host subsystem LEDs on the craft interface, which indicate the status of the CCGs. The
LEDs labeled CCG0 show the status of the Routing Engine in slot
0
State Description
On steadily SIB is functioning normally.
On steadily SIB has failed.
Off SIB is offline or absent.
On steadily SIB is in active mode and actively passing traffic.
Off SIB is either offline or not actively passing traffic.
and the CB in slot
RE0
RE1
State Description
On steadily Host subsystem is functioning as the master.
Off Host subsystem is offline or functioning as the
backup.
On steadily Host subsystem is online and is functioning normally.
Off Host subsystem is offline or absent.
On steadily Host subsystem has failed.
Off No failure has been detected.
, , and
MASTER FAIL
through . Table 9 on page 30
8
HOST0
. The LEDs labeled
CB0
and the CB in slot . Table 10
CB1
—located to the right of the
OK
CCG0 . The LEDs labeled
Copyright © 2012, Juniper Networks, Inc.
show