Programming Time Programs And Cycle Temperatures - Rotex Controller Series Product Documentation

EbV
5.4.3.4

Programming Time Programs and Cycle Temperatures

5.4.3.4.1 Switch-on time
The switch-on time defines the start of heating or the occupancy start time if the
optimization is enabled.
After selecting the weekday and the corresponding cycle the relevant switch-on time
starts to flash on the display and can be set with the rotary pushbutton. The time bar
in the upper part of the display provides an overview of all the programmed cycles
between 00:00 and 24:00 of the selected weekday.
IMPORTANT
NOTE! The switch-on time can not be set earlier than the switch-off timer of a previous cycle
and not earlier than 0:00 of the selected weekday.
When the switch-on time is changed, the relevant time bar display on the left is
adjusted.
If the switch-on time coincides with the switch-off time, the relevant cycle is deleted.
A following cycle automatically replaces the deleted cycle when confirmed.
When subsequently adding an earlier cycle the relevant weekday needs to be
reprogrammed.
A flashing switch-on time is acquired by pressing the rotary pushbutton.
5.4.3.4.2 Switch-off time
The switch-off time determines the end of heating or the end of occupancy if the
switch-off optimization is enabled.
After confirming the switch-on time the relevant switch-off time starts to flash on the
display and can be set using the rotary pushbutton. The time bar in the upper part of
the display provides an overview of all the programmed cycles between 00:00 and
24:00 of the selected weekday.
IMPORTANT
NOTE! The switch-off time cannot be later than the switch-on time of a following cycle.
When the switch-on time is changed, the relevant time bar display on the right is
adjusted.
If the switch-off time coincides with the switch-on time, the relevant cycle is deleted.
A following cycle automatically replaces the deleted cycle when confirmed.
When subsequently adding an earlier cycle the relevant weekday needs to be
reprogrammed.
A flashing switch-off time is confirmed by pressing the rotary pushbutton.
Product documentation THETA NORM/UNIT
5-25