Table of Contents
Advertisement
EbV
5.2
Code-Input
5.2.1
Installer code and OEM code
•
After entering the specialist code the parameters which are certain for the heating specialist are released
and can be processed according to the heating plant design.
•
To enter the specialist code the buttons ¥ and § have to be pressed simultaneously for approx. 3
seconds until the request to enter the code is displayed.
•
Every flashing digit can be modified with the rotary knob according to the code number and confirmed
by pressing the knob once. The further digits are treated in same way.
•
After entering all digits correctly and confirming the last digit, the specialist code is accepted:
INSTALLER OK, with wrong entry the message CODE ERROR will appear.
-
-
Caution:
Released parameters are locked again if for the duration of no further service occurs.
In this case the specialist code must be entered again.
Change code:
setting options:
OFF:
0001...9999
Operation:
5.2.2
User code
By entering a separate code, the operation of the controller can be blocked
completely against unauthorized access. Operation is only possible after entering
this code.
This function can be activated in the SYSTEM parameter.
The user code is:
Operation:
The installer code is:
The OEM code is:
The access protection is switched off, the installer parameters are
always accessible
The factory preset access code is exchanged for a value
between 1 and 9999.
Note on operation
Locking code for heating specialist
Note on operation
Activation Fahrenheit display
Product documentation THETA NORM/UNIT
Key / parametertree
SYSTEM
Key / parametertree
SYSTEM
Parameter
PARAMETER 15
Parameter
PARAMETER 23
5-17
Advertisement
Table of Contents
Need help?
Do you have a question about the Controller Series and is the answer not in the manual?
Questions and answers