Table of Contents
Advertisement
If no images can be grabbed, close the PF_GEVPlayer and adjust the Jumbo
Frame parameter (see Section 3.3) to a lower value and try again.
Figure 3.14: PF_GEVPlayer displaying live image stream
7.
Check the status LED on the rear of the camera.
The status LED light is green when an image is being acquired, and it is red when
serial communication is active.
8.
Camera parameters can be modified by clicking on GEV Device control (see Fig. 3.15). The
visibility option Beginner shows most the basic parameters and hides the more advanced
parameters. If you don't have previous experience with Photonfocus GigE cameras, it is
recommended to use Beginner level.
Figure 3.15: Control settings on the camera
MAN061 12/2018 V1.3
3.6 Getting started
25 of 103
Advertisement
Table of Contents
