1-7-3. Replacing the Anti-Glare Sheet
The two different types of anti-glare sheet are used in this unit.
Replace the desired type of anti-glare sheet as necessitated.
Required part
Anti-glare sheet (Upper) 1 piece: 3-789-424-xx
Anti-glare sheet (Lower) 1 piece: 3-789-425-xx
1. Push the release knob to release the lock and remove
the VF tube. (Refer to Section 1-7-2, step 1.)
2. Rotate the fi xed ring fully in the direction of the arrow
and align the alignment marks (red lines) of the
fi xed ring with that of the VF tube. Then remove the
VF lens unit.
n
Be extremely careful not to give any scar on the polar-
izing fi lter surface of the viewfi nder lens unit during
the removal and installation procedures.
HDVF-C30WR
Align marks
Fixed rings
(red lines)
Align marks
(red lines)
Fixed ring
VF tube
VF lens unit
Polarizing filter surface
1-13 (E)