Indications In The Lcd Panel; Removing Or Replacing A Cassette - Sony DMS-B9WD Operation Manual

Operation

Indications in the LCD Panel

The following indications may appear either during or
after the operation described on the previous pages.
Operation Indication
Power on DMS-B9
Rev. XXX.XX
SCSI ID: X ZZ
(X: SCSI ID for the DMS-B9, ZZ: Type of
the SCSI interface of the DMS-B9; WD for
Wide Differential or WS for Wide Single-
ended)
Opening the >Aborting..
door key switch
Opening the >DOOR OPEN!
front door
Closing the >DOOR CLOSED DOOR indicator lights
front door
Closing the door >Initialize..
key switch
When initializa- >IN USE
tion completed
During SCSI >IN USE
command
execution
During elevator/ >IN USE
hand movement
While the unit is operating normally, the following
indications may appear.
Indication Significance
>Aborting.. The elevator is being parked at the
bottom, ready for the door to open.
>DOOR OPEN! The door is open.
>DOOR CLOSED The door is closed.
>Initialize.. The elevator is being initialized.
>IN USE The unit is ready for use.
>MediaLocked The door key is switched to the "Open"
position, but unlocking is disabled with
the PREVENT ALLOW MEDIUM
REMOVAL command from the SCSI
set to Prevent.
>SCSI abort.. The host sends the SCSI bus reset by
turning the power ON.
14(E)
POWER indicator lights
Revision indication
SCSI ID indication
DOOR indicator flashes
BUSY indicator flashes
POWER indicator only
lights
I/O indicator lights
BUSY indicator lights
If a fault is detected while the unit is operating, the
following indications may appear.
Indication Significance
>ERROR:XXXXXX An error has occurred, stopping
operation. (For details of the error
codes, see page 30(E).)
>Init CPU I/F An SCSI interface error has occurred,
for example because the SCSI
interface is not supplied with
termination power.
∗
–– X A warning error has occurred without
stopping operation. (For details of the
warning, see page 31(E).)
X indicates an alphabet or digit.
Removing or Replacing a
Cassette
1
Turn the door key switch to the "Open" position.
The front door opens.
2
Press down the two retainer hooks.
The cassette springs out.
3
Insert a new cassette as required.