2-7. Replacing INCOM 1/2 the Connector
1. Remove the left side panel referring to Section 2-1.
2. Remove the DC/DC converter, FL-249 board and AC/DC converter referring to Sections 2-8, 2-9 and
2-10.
3. When replacing the INCOM 1 connector, disconnect CN14 on the MB-783 board. When replacing
the INCOM 2 connector, disconnect CN15 on the MB-783 board.
4. Remove the two screws securing the connector that needs to be replaced and pull it out. Replace the
connector with harness with a new one.
5. Install a new connector in the reverse order of removal.
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
When reinstalling the FL-249 board, refer to Section 2-9 for proper connection.
K2.6
CA-570 P1
INCOM1
connector
K2.6
X
6
X
6
CN15
CN14
MB-783 board
2-7. Replacing INCOM 1/2 the Connector
< Left side >
2-7 (E)