Setting Up Your Workstation; Prepare Your Workspace - HP x4000 Getting Started Manual

Setting Up And Using Your Workstation

Setting Up Your Workstation

Setting Up Your Workstation
WARNING If you have any doubt that you can lift the workstation and
monitor safely, do not try to move them without help.
The following topics explain how to set up your x4000 Workstation. Some
steps may not apply to your situation.
•
•
•
•
•
•
•

Prepare your Workspace

Installation Tools
No tools are required to set up your workstation unless you are installing
a graphics card. If you are installing a graphics card, you need a T-15
Torx driver and a flat-blade screwdriver.
10
This manual downloaded from http://www.manualowl.com
"Prepare your Workspace" on page 10
"Install Your Graphics Card" on page 11
"Connect the Components" on page 11
"Connect the Audio Accessories" on page 13
"Connect to a Network (LAN)" on page 13
"Load the Software Applications for Your CD-RW" on page 14
"Connect the Power Cords" on page 14
1. Unpack all of the components.
2. Place the monitor on a sturdy desk with easily accessible power
outlets and enough space for the keyboard, mouse, and any other
accessories.
3. Position the workstation on a sturdy desk or the floor with the rear
connectors easily accessible. The workstation must be close enough
to the peripherals so that the cables can be connected.
Chapter 1