Audio Doesn't Work; Cd-Rw Doesn't Work; Forget Your Password - HP x4000 Getting Started Manual

Audio Doesn't Work

The internal speaker is deactivated when you use the output line jack on
the rear of the workstation. If you have connected the multimedia
keyboard's audio out (green) connector to this jack, you must connect
speakers or headphones to the multimedia keyboard for audio output. If
you don't have speakers or headphones, disconnect the keyboard's audio
out connector from the back of the workstation to enable the internal
speaker.

CD-RW Doesn't Work

If you can read a CD in your CD-RW, but you can't write to a CD, you
may be missing the CD-RW application software.
If you have a CD-RW in your workstation, you must install the software
that came with the drive before you can write to the device as described
in "Load the Software Applications for Your CD-RW" on page 14.
The CD-ROM and DVD drivers were pre-loaded in your workstation at
the factory, the two CD-RW applications were not.

Forget Your Password?

Clearing the User Password
If you forgot your User password and remember the Administrator
password, you can clear the User password through the setup menu.
To clear the User password:
Chapter 2
This manual downloaded from http://www.manualowl.com
1. Start the Setup Program as described in "Starting the HP Setup
Program" on page 20.
2. Enter the Administrator password when prompted.
3. Navigate to the Security menu.
4. Select
Clear all Passwords
5. Enter and confirm a new User password if needed.
6. Press to leave the Security menu.
ESC
7. Select
Exit Saving Changes
Solving Hardware Problems
.
to save your changes.
Troubleshooting
33