HP x4000 Getting Started Manual page 21

The opening screen of the workstation's Setup program is displayed. The
Main Menu presents a list of fields, such as the installed BIOS version
and the Date and Time.
A band along the top of the screen offers a list of menus. Select one of the
following menus by using either the left or right arrow keys.
A band along the bottom of the screen gives instructions on using the
keyboard-driven menus.
Main Menu
In the Main menu, you can:
•
•
•
•
By default, "Reset Configuration Data" is set to
configuration causes the BIOS to assign resources to all devices instead
of using what is stored in memory.
Advanced Menu
The Advanced menu offers a list of sub-menus that let you view or
configure:
•
•
•
•
•
Chapter 1
This manual downloaded from http://www.manualowl.com
2. Press while
F2 F2 Setup
If you fail to press
F2
must allow your system to finish booting up, then restart your
workstation and go through the Power-On-Self-Test (POST) again.
view the BIOS version
reset configuration data
set the system time
set the system date
processor speed
advanced features of the chip set
PCI cards
the Advanced Graphics Port video card
settings for the integrated:
— floppy disk drive controller
— IDE controller and for attached IDE devices
— SCSI controller
— 10/100BT network interface
— serial (A and B) and parallel ports
— PCI audio controller
Setting Up And Using Your Workstation
Using Your x4000 Workstation
is displayed at the bottom of the screen.
in time and the start-up process continues, you
. Resetting the
No
21