Using Your X4000 Workstation; Understanding The Control Panel - HP x4000 Getting Started Manual

Using Your x4000 Workstation

Understanding the Control Panel

The hardware control panel, located on the front of the workstation, is
shown in Figure 1-3.
Figure 1-3 Hardware Control Panel
•
•
•
Chapter 1
This manual downloaded from http://www.manualowl.com
Hard Disk
Activity LED
Reset Button
Power On/Off button: Press this button to start the workstation. You
can also wake the workstation from Hibernate or Stand By mode by
pressing this button for less than four seconds. Press this button for
more than four seconds to turn the workstation off.
Power LED:
— Solid green indicates system on.
— Solid yellow indicates the workstation is in Stand By or
Hibernate mode. See "Using Power Management" on page 24.
— Flashing yellow, flashing red, or solid red indicates a system
error. See "Understanding the Diag LEDs" on page 35.
Reset button: Press this button to re-initialize all the hardware
without cycling power to the system (soft boot). Avoid general use of
this button because file damage may occur. Always use the operating
system command before resetting the machine.
Shut Down
Setting Up And Using Your Workstation
Using Your x4000 Workstation
Power On/Off and Power LED
Network
Activity LED
Diagnostic LEDs
15