If-1331 Board (Hdc-P50) - Sony HDC-P50 Service Manual

4-12. IF-1331 Board (HDC-P50)

Preparation
1. Remove the outside assembly. (Refer to "4-4. Outside Assembly")
2. Remove the inside assembly. (Refer to "4-5. Inside Assembly")
3. Remove the front panel block. (Refer to "4-7. Front Panel Block")
4. Remove the CMOS block assembly. (Refer to "4-8. CMOS Block Assembly (HDC-P50)")
5. Remove the FD assembly. (Refer to "4-9. FD Assembly (HDC-P50)")
Procedure
1. Disconnect the harness from the connector (CN006) on the IF-1331 board.
2. Remove the two screws, and then remove the IF holder cover (860).
3. Disconnect the four fine-wire coaxial cables from the four connectors (CN001 to CN003 and CN005) on the IF-1331 board.
4. Disconnect the lead wire with connector from the connector (CN007) on the IF-1331 board.
5. Remove the two screws, and then remove the IF-1331 board.
CMOS block assembly
6. Install the removed parts by reversing the steps of removal.
Fine-wire coaxial cable (IF-BI (40))
CN003
CN001
Fine-wire coaxial cable (IF-BI (40))
IF holder cover (860)
Yellow
IF-1331 board
CN007
PSW
2 x 5
Fine-wire coaxial cable (IF-BI (40))
Fine-wire coaxial cable (SY-IF (50))
CN002
CN005
CN006
Lead wire with connector
Harness
PSW
2 x 5
40