Cmos Block Assembly (Hdc-P50) - Sony HDC-P50 Service Manual

4-8. CMOS Block Assembly (HDC-P50)

Preparation
1. Remove the outside assembly. (Refer to "4-4. Outside Assembly")
2. Remove the inside assembly. (Refer to "4-5. Inside Assembly")
3. Remove the front panel block. (Refer to "4-7. Front Panel Block")
Procedure
1. Peel the tape.
2. Remove the two harnesses from the two hooks of the OHB duct.
3. Remove the harness from the two harness clamps.
Tape
OHB duct
Harness clamps
4. Remove the four hexagon socket stainless bolts and four washers, and then remove the front panel block.
Washers
Hexagon socket
stainless bolts
5. Install the removed parts by reversing the steps of removal.
Hooks
Harnesses
CMOS block assembly
Front panel assembly
Front panel block
36