Sony HDC-P50 Service Manual page 46

6. Install the removed parts by reversing the steps of removal.
Note
• When installing the filter knob, install the filter knob as follows.
(1) Align the position of the filter shaft as follows.
Rotate the filter shaft clockwise to make
the filter most transparent.
(2) Attach the filter sheet.
Filter shaft
Filter sheet
(3) Install the front panel assembly.
(4) Align the filter knob number "2" with the inside, and then attach the filter knob.
(5) Apply locking compound (1401B), and then tighten the set screw.
Set screw
Apply locking compound (1401B)
half rice grain size.
(The size of a grain of rice means
about 20 μL.)
Filter shaft
Filter
(Most transparent)
Front panel assembly
2
Set screw
Filter knob
Rotate the filter shaft clockwise 90°.
(Confirm that the D cut on the SE-1216 board is
in the position as shown in the figure.)
Filter shaft
D cut
SE-1216 board
43