Front Panel Block - Sony HDC-P50 Service Manual

4-7. Front Panel Block

Preparation
1. Remove the outside assembly. (Refer to "4-4. Outside Assembly")
2. Remove the inside assembly. (Refer to "4-5. Inside Assembly")
Procedure
1. Disconnect the harness from the connector (CN203) on the MB-1259 board.
Harness
2. Disconnect the fine-wire coaxial cable from the connector (CN105) on the SY-471 board.
3. Disconnect the harness from the connector (CN101) on the SY-471 board.
4. Remove the four screws, and then remove the front panel block.
Front panel block
B3 x 10
5. Install the removed parts by reversing the steps of removal.
Upper side
CN203 MB-1259 board
SY-471 board
CN105
CN101
Harness
Fine-wire coaxial cable
This figure shows HDC-P50.
35