Sony BCU-100 Maintenance Manual page 32

. Configure the COM port setting of the PC.
(Be sure to connect the connection cable to the COM port before the setting.)
COM port setting procedure
(1) Enter "0" in the main menu, and press the [OK] button. The following dialog box appears. Click
[Yes] to proceed.
(2) The TeraTermPro terminal screen appears. Select [Setup], and then [Serial port]. The following
dialog appears. Set the port in this dialog. Be sure to set a usable port. (Check usable ports in Port
(COM) in the Device Manager.)
The settings for the other items are as follows.
(3) When the setting is completed, return to the TeraTermPro terminal screen. Select [Setup], and then
[Save setup] to save the TeraTerm setting file.
(4) After saving the file, close the TeraTermPro terminal screen.
The port setup is completed.
4. Diag mode startup procedure
. Connect the power supply cord to the BCU-100. (Standby state)
. When the TeraTerm macro is executed, the BCU-100 starts to run in the Diag mode.
5. Log file
The result of executing each dialog is automatically saved as a log file.
Check the saved log file as necessary.
The file format and the directory of the destination folder are as follows.
Format:
Diagnostic name_Date_Serial number.log
*Date: YYYYMMDD, Serial number: from 1
Directory:
Installation folder of TeraTermPro\bcu100log
1-24 (E)
BCU-100 MM