Table Of Contents; Please Read This First - Carlin 801GAS Instruction Manual

PLEASE read this first . . .

Contents
PLEASE read this first . ................................................................2
General information . ....................................................................3
1. The Carlin Model 801GAS combination gas burner . ............4
2. Prepare site • assemble burner • mount burner ...........5
3. Install gas piping . ................................................................11
4. Wire the burner . ..................................................................12
5. Checkout procedure - before starting the burner . ..............15
6. Set burner initial head and damper positions .....................16
7. Adjust the burner using test instruments ............................16
8. Maintenance and service procedures ................................20
9. Dimensions . ........................................................................22
10. Repair parts . .......................................................................24
User care and maintenance ........................................ Rear cover
Special attention flags . . .
Please pay particular attention to the following when you see them
throughout this manual.
Notifies you of hazards that WILL cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that CAN cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor
personal injury or property damage.
Notifies you of special instructions on installation, operation
or maintenance that are important, but are not normally
related to injury or property damage hazards.
- 2 -
Before installing or
servicing:
Should overheating occur:
(1) Shut off the gas supply to the burner.
(2) DO NOT shut off the control switch to the boiler
circulator or the burner.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property dam-
age.
Installer/service technician . . .
Read all instructions before proceeding. Perform all procedures,
•
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
Before leaving the site after startup or service, review the User
•
care and maintenance page with the user. Make the user aware
of all potential hazards and perform the training outlined below.
Installer/service technician -
Train the user . . .
To properly operate the burner/appliance per this manual and
•
the appliance instructions. See User care and maintenance.
To keep this manual at or near the burner/appliance for ready
•
access by the user and service technician.
To contact the service technician if he encounters problems with
•
the burner/appliance.
To keep the appliance space free of flammable liquids or vapors
•
and other combustible materials.
To never use laundry products, paints, varnishes or other chemi-
•
cals in the room occupied by the burner/appliance.
To contact the service technician at least annually for startup and
•
burner/appliance service.
When servicing the burner . . .
DISCONNECT ELECTRICAL SUPPLY and all other electrical
•
connections to burner before attempting to service to avoid
electrical shock or possible injury from moving parts.
CLOSE all manual gas valves before disconnecting any portion
•
of fuel lines and before cleaning or removing any parts from the
burner or related equipment.
Burner and appliance components can be extremely hot. Allow
•
all parts to cool before attempting to handle or service to avoid
potential of severe burns.
MN801GAS 060520