Table of Contents
Advertisement
3
IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard's IDE connector, then select one of the following modes
to configure your device(s).
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select", make sure all other device
jumpers have the same setting.
4.
CPU Fan Connectors
(4-pin CPU_FAN)
The fan connectors support cooling fans of 350mA~740mA (8.88W
max.) or a total of 1A~2.22A (26.64W max.) at +12V. Connect the fan
cables to the fan connectors on the motherboard, making sure that the
black wire of each cable matches the ground pin of the connector.
4-6
IDE connectors
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
NOTE:Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN1.
Mode of
Cable connector
device(s)
-
Black
Black
Master
Slave
Gray
Master
Black or gray
Slave
Chapter 4: Motherboard info
Advertisement
Table of Contents
Need help?
Do you have a question about the V2-M2V890 and is the answer not in the manual?
Questions and answers