Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Asus V3-M2V890
Summary of Contents for Asus V3-M2V890
- Page 1 Q2748 V-Series M2V890 ASUS PC (Desktop Barebone) Quick Installation Guide...
-
Page 2: Front Panel Features
Refer to the system user guide for installation details and other system information from ASUS website. Front panel features 5 . 2 5 - i n c h d r i v e bay cover 3 . 5 - i n c h d r i v e b a y... -
Page 3: Internal Components
Internal components M2V-TVM Front panel cover ASUS motherboard 5.25-inch optical drive bays Chassis fan Hard disk drive bay 10. PCI Express x16 slot Floppy disk drive bay 11. PCI Express x1 slot Power supply unit 12. PCI slots CPU socket 13. -
Page 4: Removing The Side Cover And Front Panel Assembly
Removing the side cover and front panel assembly Remove the cover screws on the rear panel. Pull the side cover toward the rear panel until its hooks disengage from the chassis tabs. Set the side cover aside. Locate the front panel assembly hooks, then lift them until they disengage from the chassis. -
Page 5: Installing The Cpu Fan And Heatsink Assembly
Install the CPU to the socket, making sure that the CPU corner with the gold triangle matches the socket corner with a small triangle. Push down he socket lever to secure the CPU. Installing the CPU fan and heatsink assembly Place the heatsink on top of the installed CPU, making sure that the heatsink fits properly on the retention module base. -
Page 6: Installing A Dimm
Installing a DIMM Locate the DIMM sockets in the motherboard. Unlock a DIMM socket by pressing the retaining clips outward. Align a DIMM on the socket such that the notch on the DIMM matches the break on the socket. Push the DIMM to the socket until the retaining clips snap inward. •... -
Page 7: Installing Storage Drives
Installing storage drives Optical drive Place the chassis upright, then remove the upper 5.25” drive bay metal plate cover. Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the optical drive with two screws on both sides of the bay. -
Page 8: Removing The Bay Covers And Reinstalling The Front Panel Assembly And Side Cover
For SATA HDD: Connect the SATA SATA signal and power plugs to the connectors at the back of the drive. For IDE HDD: Connect the IDE signal and power plugs to the connectors at the back of the drive. Removing the bay covers and reinstalling the front panel assembly and side cover If you installed an optical and/or floppy disk drive, remove the bay cover(s) on the front panel assembly before reinstalling it to the chassis.